Rabbeting; Ploughing And Molding - RIDGID TS 2400 Operator's Manual

Basic Saw Operations (continued)

Rabbeting

Rabbeting is known as cutting out a sec-
tion of the corner of a piece of material,
across an end or along an edge.
To make a rabbet requires cuts which do
not go all the way through the material.
Therefore, the blade guard must be
removed.
1. Remove blade guard.
2. For rabbeting along an edge (long way
of workpiece) as shown add facing to
rip fence approximately as high as the
workpiece is wide. Adjust rip fence and
blade to required dimensions; then
make first cut with board flat on table as
any rip (type) cut; make second cut with
workpiece on edge. Follow all precau-
tions, safety instructions, and opera-
tional instructions as for ripping, or rip
type operations,
boards and push stick, etc.
3. For rabbeting across an end, for work-
piece 10-1/2" and narrower, make the
rabbet cut with the board flat on the
table. Using the miter gauge fitted with
a facing, follow the same procedures
and instructions for cross cutting mak-
ing successive cuts across the width of
the workpiece to obtain the desired
width of cut. Do not use the rip fence for
rabbeting across the end.
WARNING: For your own safety,
install blade guard immediately
upon completion of rabbeting
operation.
Some rabbet cuts can also be made in
one pass of the workpiece over the cutter
using a dado head.

Ploughing and Molding

Ploughing is grooving with the grain the
long way of the workpiece, using the
fence. Use featherboards and push sticks
as required.
including feather-
Second Cut
Rabbet
Second
Cut Etc.
First
Cut
Ploughing
52
This Side
Against Fence
When Making
Second Cut
First Cut
Rabbet