Advertisement
NS-300
ATTACHING THE STAND
Stand x 4
Screw (6 mm) x 4
Washer x 4
When positioning the speakers, be sure to use the stand to
increase stability.
Use the 8 specified holes located on the base of the
speaker.
Procedures
1. Put the 6 mm screw through the inside hole on the
stand.
2. Place a washer on the screw on the speaker side of the
stand and attach to the speaker at one of the outside
holes on the base os the speaker.
At this time, attach the stand so that it can still be moved
slightly.
3. Put the 4 mm wood screw through the outside hole on
the stand, and screw into the inside hole on the base of
the speaker.
4. When both screws have been sttached, tighten both of
the screws so that the stand is firmly in place.
Be sure to check that the stand is firmly sttached.
5. Attach the pads to the bottom of the end portion of the
stand.
6. Attach the other stands in the same manner and confirm
that all 4 stands have been firmly sttached.
7. Place the speaker in the desired location.
Note
If force is applied to the side of the speaker, it may fall
and damage the speaker or couse personal injury.
Please be careful.
Wood screw
(4 mm) x 4
Pad x 4
ATTACHING THE SPIKE
Spike x 4
When setting up the speakers on a thick carpet, use the
spikes instead of the stand. With 4 points set in place to
achieve increased stability and improvements in sound
quality.
Procedures
1. Set the nut close to the tip of the spike and screw them
into the bottom of the speaker at each of the four
specified holes.
2. Place the speaker in the desired location in an upright
position and adjust the length of the spike to match the
depth of the carpet.
3. When adjustment is complete, twist the nut up to the
base of the speaker firmly.
Notes
• The tips of the spikes may scratch or otherwise
damage the flooring. Please be careful when
positioning the speakers.
• If force is applied to the side of the speaker, it may
fall and damage the speaker or cause personal
injury.
Please be careful.
Nut
Advertisement
