Stihl FS 311 Instruction Manual page 31

Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until the engine
N
runs.
As soon as the engine runs
Press down the throttle trigger
N
lockout and open the throttle – the
choke knob moves to the run
position F. After a cold start, warm
up the engine by opening the
throttle several times.
FS 311
WARNING
There is a risk of injury if the cutting
attachment runs when the engine is
idling. Adjust the carburetor so that the
cutting attachment does not run when
the engine is idling – see "Adjusting the
Carburetor".
Your machine is now ready for
operation.
Stopping the Engine
Depress the momentary contact
N
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration.
Move the choke knob to < and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position <
Move the choke knob to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Engine is flooded
Move the choke knob to F and
N
continue cranking until the engine
runs.
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is already filled with
fuel.
Set the choke knob to suit the
N
engine temperature.
Now start the engine.
N
English
29