Maytag Jetelean DWU7910AAE Repair Manual page 10

Jetelean series
Table of Contents

Advertisement

Options
Delay
Start
You can delay the start of the Pots & Pans cycle
Temp
Boost
Sensor
up to six hours. To set up a delay, turn the dial to
If for any reason the incoming water
the number of hours you would like the Pots &
temperature
is below 120°F, press the On
Pans cycle delayed,
button to assure the water is heated to proper
temperatnre
for best cleaning and diNing
To Start
Dishwasher
results. The dial will panse at the _ to extend
After loading set the dial to the desired cycle.
the main wash and the Heating Delay" light will
Press button for desired options.
turn on.
NOTE: Run the water from the hot water tap to
Press the Off button to cancel the Temp Roost
clear the line of cold water before
Sensor.
starting.
Heated
Rinse
and
Dry Options
Press the door until it latches. The cycle will
begin with a drain prior to fill and the On
RINSE TEMP
indicator will light.
Press the Sani button to turn the heating
element on during all rinses. The Sani option
Indicator
Lights
helps maiutain water temperature
and improve
When Delay" Start is selected the Delay Start
dining results,
light glows until the cycle begins. The On light
Press the Normal button if Sani is not desired,
indicates that the dishwasher is operating. At
The heating element will be turned offin all
the end of the dry" phase Clean will remain lit
until the dial has been advanced to the (_. The
rinses.
Heating Delay" light indicates that the main
FAN DRY
wash is being extended to heat the water to
Press the Heat button to turn the beating
proper temperature.
element on during the f_mdry period. This
option improves dr_4ng results.
Adding
a Forgotten
Item
Press the Air button to tuln the heating element
For best cleaning, the forgotten item should be
off during the fan dry;period. Towel drying may
added early in the cycle.
be necessary.
1. Unlatch the door and wait until the sound of
NOTE: Temp Boost Sensor, Rinse Temp and
circulating water stops.
Fan Dry"options can be used separately
2. Open the door and add the item.
or together.
3. Panse before latching the door. The cycle will
continue at the point it was intem_pted.
PAGE 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents