Table of Contents
Advertisement
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.
Place the battery pack in the drill, aligning raised rib on
battery pack with groove in the tool's battery port.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured to the
drill before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom
of the drill and latches into place properly. Improper
installation of the battery pack can cause damage
to internal components.
TO REMOVE BATTERY PACK
See Figure 5.
Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
drill.
Remove the battery pack from the drill.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
SWITCH TRIGGER
See Figure 6.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed and
torque with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
DEPRESS LATCHES TO
RELEASE BATTERY PACK
12
RAISED RIBS
LATCHES
Fig. 4
Fig. 5
Advertisement
Table of Contents
