Figure 2: Jumper Table, Marked On The Em22Xx Evaluation Board Silk Screen - Intel EM2260 User Manual

5) Set the output voltage
Using the chart from the silkscreen, please select the desired output voltage, using

ONLY ONE switch ON. This setting will be read by the module when the part is
powered on; changing the resistor on the fly will not have any effect.
6) Power-up the board
After all preparations above, the board should be ready to perform.

The voltage range is marked on the board, as shown in Figure


Figure 2: Jumper Table, Marked On The EM22xx Evaluation Board Silk Screen

For instruction on how to use the EM22xx GUI, please read "GUI User Guide."

NOTE: To measure the Bode Plot of the DC-DC converter, J12 must be populated which is then used to connect the
probes of the phase analyzer.
14716
User Guide | Intel® Enpirion® Power Solutions
Vout Settings
0V50 V1
0V70 V2
0V85 V3
0V90 V4
0V95 V5
1V00 V6
1V15 V7
1V20 V8
Aprril 13, 2018
EM22xx Evaluation Board User Guide
2:
6
Rev A