Table of Contents
Advertisement
Page 36
FIRST YEAR-WARRANTY FOR SG SERIES RESIDENTIAL HOT WATER BOILERS:
QHT warrants that its cast-iron boiler and casing are free from defects in material and workmanship for one year from the date of
installation. If the boiler is found to be defective within this period, QHT will replace the boiler block or casing.
LIFETIME WARRANTY-WARRANTY FOR THE CAST IRON BOILER BLOCKS OF THE SG SERIES RESIDENTIAL BOILERS:
Biasi warrants that the cast-iron sections and nipples of the BIASI SG boilers are free from defects in material and workmanship for
the lifetime of the original single family home installation. If the SG boiler block is then found to be defective, QHT and Biasi will
replace the original cast iron boiler block.
These warranties are subject to the condition that a heating contractor whose principal occupation is the sale and installation of
heating equipment must have installed the boiler. PARTS, WHICH ARE COVERED, consists of all materials supplied by Biasi,
identified by QHT's part numbers in its literature. Other parts supplied in the casing, trim kit or in the burner pack carry their own
warranty and each manufacturer has responsibility for its own products.
NOTE: ANY PART, WHICH IS REPLACED UNDER WARRANTY, CARRIES ONLY THE UNEXPIRED PORTION OF THE
ORIGINAL WARRANTY.
OWNER RESPONSIBILITIES:
1.
Provide for proper installation, which includes pressure relief and pressure reducing valves and high limit safety controls on
closed systems.
2.
Provide qualified periodic service to prolong proper operation and service.
3.
Insure that boiler is installed with approved burner and that installation conforms to all codes and ordinances.
4.
This warranty does not apply to boilers, which are subject to misuse, abuse, neglect, alteration, accident, excessive
temperature, excessive pressure, or corrosive water or atmosphere.
5.
Owner will be responsible for return of faulty components to Portsmouth, NH, freight pre-paid.
QHT and Biasi will not be responsible for:
1.
Components that are part of the heating system, but were not manufactured by Biasi or QHT as part of the boiler.
2.
The workmanship of the installers of SG boilers. Furthermore, this warranty does not assume any liability for unsatisfactory
performance caused by improper installation.
3.
Any costs for labor to remove or replace the faulty component.
4.
Improper burner application or adjustments, control settings, care or maintenance.
5.
Any damage associated with corrosion or leakage due to the use of "non-barrier", plastic pipe in the heating system.
THIS WARRANTY DOES NOT EXTEND TO ANYONE EXCEPT THE FIRST PURCHASER AT RETAIL AND ONLY WHEN
THE BOILER IS IN THE ORIGINAL INSTALLATION SITE.
IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY SHALL BE LIMITED TO
THE DURATION OF THE EXPRESSED WARRANTY. BIASI AND QHT EXPRESSLY DISCLAIM AND EXCLUDE ANY
LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF ANY EXPRESSED OR IMPLIED
WARRANTY.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS THAT VARY FROM STATE
TO STATE.
For prompt warranty service, notify the installer, who, in turn, will notify the distributor from whom he purchased the boiler. If this
does not result in corrective action, contact Biasi through Quincy Hydronic Technology (Address Below) with details in support of
the warranty claim. All claims must be processed through proper trade channels. Contact with Biasi directly is not recommended
for rapid claim settlement.
Item#: SG/C-REV 011117
For BIASI SG Pro Series Residential
Cast-Iron Water Boilers
Quincy Hydronic Technology,
3560 Lafayette Rd.
Portsmouth, NH, 03801
Tel. (603) 334-6400
www.qhtinc.com
Warranty
Manufactured by:
BIASI S.p.A.
Verona, Italy
Biasi SG Pro Series
Advertisement
Table of Contents
