Toshiba B-EX6T1 Owner's Manual page 20

2. PRINTER SETUP
2.3.1 Loading the Media
(Cont.)
NOTE:
Do not over-tighten the Locking
Ring of the Supply Holder.
ENGLISH VERSION
7. Align the tab of the Supply Holder with the groove in the Supply
Shaft, and push the Supply Holder against the media until the media
is held firmly in place. This will center the media automatically.
Turn the Locking Ring clockwise to secure the Supply Holder.
In the case of media which is
inside wound.
Media
8. Place the media between the Media Guides and adjust them to the
media width. Once in the correct position tighten the Locking Screw.
9.
Check that the media's path through the printer is straight. The
media should be centered under the Print Head.
Paper guide
holder
E2-6
Supply Holder
Guide Shaft
Supply Shaft
In the case of media which is
outside wound.
Guide Shaft
Print Head
Media
2.3 Loading Supplies
Tab
Groove
Locking Ring
Supply Holder
Media Guide