Harman Kardon AVR210 Manual page 11

The first step to correct this problem is to turn the 2.0 off using the
Master Power Switch and unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and turn the unit on again. If the system still malfunctions, a system
reset may clear the problem. To reset the system, press the Menu
button to view the Setup Menu. Press the Menu Control button until
Advanced Setup is highlighted. Press the Menu Control button to go to
the next screen. At the Advanced Settings menu, press the Menu
Control button twice until SYSTEM RESET is highlighted. Press the
Menu Control button again. This will bring up the System Reset Menu.
If you wish to exit at this point, press the Menu button. To proceed with
Signature 2.0
the reset, press the Menu Control button to move the highlighted area
to the Yes line, and then press the Menu Control button. The next
screen instructs you to proceed by pressing and HOLDING the Store
button until the reset is complete. Follow that instruction by holding the
Store button until the Reset Completed message appears briefly on
screen and the front panel Information Display. This is your indication
that the reset has been accomplished, and you may release the Store
button. The system will automatically return to the Advanced Settings
menu. After a reset the system is returned to the original factory default
settings, the microprocessor system is re-initialized. Press the Menu
button twice to return to normal operation.
Model
To correct this problem, first unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and check the unit's operation. If the system still malfunctions, a
system reset may clear the problem. To clear the DCR600's entire
DCR600
system, first put the unit in Standby by pressing the System Power
Control button. Next, press and hold the Tone Mode and the FM Mode
Selector buttons for three seconds. The unit will turn on automatically
and display the RESET message in the Main Information Display
To correct this problem, first unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and check the unit's operation. If the system still malfunctions, a
system reset may clear the problem. To clear the DCR600II's entire
DCR600II
system, first put the unit in Standby by pressing the System Power
Control button. Next, press and hold the Tone Mode and the FM Mode
Selector buttons for three seconds. The unit will turn on automatically
and display the RESET message in the Main Information Display
In the event that you forget the password for the DVD600, you may reset
it to the factory default by following this procedure: In Standby mode,
press the Search Back and Skip Forward buttons on the front panel
DVD600
simultaneously for more than 3 seconds. The Information Display will
light, and a test pattern will appear on your TV. Press Power On to
proceed.
In the event that you forget the password for the DVD600II, you may
reset it to the factory default by following this procedure: In Standby
mode, press the Search Reverse and Skip Forward buttons on the
DVD600II front panel simultaneously for more than 3 seconds. The Information
Display will light, and a test pattern will appear on your TV. Press the
System Power Control to proceed.
JBL
Instructions Comment
PASSWORD RESET ONLY
PASSWORD RESET ONLY