Store Tracks To St-G30 - Technics ST-G30 Control Manual

Store tracks to ST-G30

• Also see LEGAL NOTICE. (⇒ 2)
Record tracks from the CD
1
Insert the CD to ST-G30.
• For how to insert a CD, see the operating
instructions supplied with ST-G30.
2
Tap [ST-G30 Menu] > Device selection > [Record from
CD].
®
• The Gracenote
and the title, artist information, etc. of the CD
to record are automatically obtained from the
®
Gracenote database.
– It may take time to obtain the information.
– Obtaining the information requires the router to
be connected to the Internet.
– If more than one piece of information is found
on the database, the candidates are listed.
Select the information you wish to obtain from
the list.
– If the information is not present on the
®
Gracenote
If the information cannot be obtained, the
album name and artist name are registered
as [Unknown Album] and [Unknown Artist]
respectively.
– The title and artist information, etc. can be
changed by editing after recording. (⇒ 13)
3
Tap [Start recording].
• The recording of all tracks starts.
• When the router is connected to the Internet, the
recording data is compared to the exclusive server
for the bit-perfect. Normal playback is not affected
even if the data is not bit-perfect.
Bit-perfect is the condition of the music data
without any interpolation.
The following icons will be displayed for the tracks
for which the recording is completed. If either of
the icons is displayed for all the tracks, the recording
is completed. If you record from the CD again, start
from step 1.
– [ ]:
Bit-perfect recording is completed.
– [ ]:
Recording is completed.
Tap the icon to check the cause that resulted in
failure of bit-perfect recording.
logo is displayed for a few seconds,
database, it cannot be obtained.
8