Honeywell HDZ302LIK Configuration Manual page 22

22 | HDZ IR Series OSD Configuration Guide
AUTO SCAN
Move the cursor to AUTO SCAN and click the confirm button to go to the submenu, where you
can view or modify the following settings:
• AUTO SCAN NO
• SET LEFT LIMIT
• SET RIGHT LIMIT
• SCAN SPEED
• CALL
• STOP
TOUR
Move the cursor to TOUR and click the confirm button to go to the submenu, where you can
view or modify the following settings:
• TOUR NO
• TOUR SETTING
• DELETE TOUR
• CALL
• STOP
www.honeywell.com/security
Sets the auto scan number. Click the left/right button to set.
Sets the camera left limit. Move the PTZ to the desired position
and then click the confirm button.
Sets the camera right limit. Move the PTZ to the desired
position and then click the confirm button.
Sets the scan speed. Click the left/right button to set (1–8).
Input the auto scan number, move the cursor to CALL, and
then click the confirm button to activate auto scan.
Move the cursor to STOP and click the confirm button. Auto
scan stops.
Sets the tour number. Click the left/right button to set.
Move the cursor to TOUR SETTING and click the confirm
button. Here you can add or remove presets and set the
corresponding dwell time and call speed.
• DWELL: Click the left/right button to set the dwell time.
• SPEED: Click the left/right button to set the speed value
(1–8).
When you move the cursor to one tour number, you can use
left/right button to turn the page. When you move the cursor to
one tour number, click the confirm button to set the tour.
Use the up/down button to set preset number, dwell time, and
speed. Use the left/right button to go to the next tour. Click the
confirm button to exit the setup.
Input the tour number, move the cursor to DELETE, and then
click the confirm button.
Input the tour number, move the cursor to CALL, and then click
the confirm button to activate touring.
Move the cursor to STOP and click the confirm button. Touring
stops.