Download Print this page

Brookstone RACER Quick Manual

App-controlled micro car

Advertisement

Quick Links

IMPORTANT SAFETY
INSTRUCTIONS
All of the safety and operating
instructions should be read, adhered to
RACER
and followed before the unit is operated.
WARNING
APP-CONTROLLED MICRO CAR
For ages 6 and up.
This product may contain small parts,
which may pose a choking hazard to
children.
Close supervision is necessary when
this unit is used by or near children or
mentally disabled individuals.
Use this unit only for its intended use
as described in this manual.
The unit should be situated away from
direct sunlight or heat sources such as
radiators, electric heaters, heat registers,
stoves or other units that produce heat.
The product is recommended for indoor
use only.
Make sure there are no insurmountable
obstacles or breakable objects in the
unit's path.
The product is not waterproof. Do not
spray or pour liquid on it, and do not
immerse it in liquid.
Special Note to Adults:
Parental
guidance is recommended when
installing or replacing batteries.
Regularly examine the toy for damage.
In the event of any damage, the toy
must not be used until the damage has
• Carefully read the instruction guide
been repaired. This toy is not intended
and use the batteries correctly.
for children under 3 years old.
• In the unlikely event of leakage or
explosion use sand or a chemical fire
BATTERY SAFETY INFORMATION:
DO NOT dispose of this product in fire,
extinguisher for the battery.
as batteries inside may explode or leak.
• Batteries must be recycled or
DO NOT dispose of batteries in fire, as
disposed of properly.
batteries may explode or leak. DO NOT
short-circuit the supply terminals.
PRODUCT BATTERY REMOVAL
INSTRUCTIONS:
Internal battery is
WARNINGS CONCERNING THE
factory installed, product disassembly
USE OF THE BATTERY
and battery removal must be performed
by an adult. Do not puncture, cut, tear,
Your BT App Controlled Car is equipped
compress or deform product during
with a Lithium Polymer battery.
disassembly. Ensure product is turned
SPECIAL LI-ION BATTERY
off, then use a screwdriver to remove
INSTRUCTIONS:
all screws. separate product body
• Never charge battery unattended.
halves to expose internal electronics.
• Charge battery in isolated area. Keep
When battery is visible in its entirety
away from flammable materials.
use scissors to cut a single battery wire,
immediately wrap the cut wire end with
• Do not expose to direct sunlight.
There is a risk of the batteries
tape to isolate it, repeat until all battery
wires are cut and isolated, and the
exploding, overheating, or igniting.
battery is free from the rest of the
• Do not disassemble, modify heat, or
product. Dispose of battery in
short circuit the batteries.
accordance with your local battery
• Do not place them in fires or leave
recycling or disposal laws.
them in hot places.
NOTE: Opening of product and/or
• Do not drop or subject to strong
removal of battery will render product
impacts.
inoperative and voids manufacturer
• Do not allow the batteries to get wet.
warranties, dispose of remaining
product components in accordance
• Only charge the batteries with the
specified battery charger.
with local laws.
• Only use the batteries in the device
specified by brookstone.
Battery disposal
to this unit not expressly approved by
the party responsible for compliance
Contains 1 x 3.7 V, 150mAh
could void the user's authority to
Li-ion battery pack. Batteries
operate the equipment. Note: This
or battery packs must be
equipment has been tested and found
recycled or disposed of
to comply with the limits for a Class B
properly. When this product has
digital device, pursuant to Part 15 of the
reached the end of its useful life it
FCC Rules. These limits are designed
should not be disposed of with other
to provide reasonable protection against
household waste. The Waste Electrical
harmful interference in a residential
and Electronic Equipment Regulations
installation. This unit generates uses
require it to be separately collected so
and can radiate radio frequency energy
that it can be treated using the best
and if not installed and used in
available recovery and recycling
accordance with the instructions, may
techniques. This will minimize the
cause harmful interference to radio
impact on the environment and human
communications. However, there is no
health from soil and water contamination
guarantee that interference will not
by any hazardous substances, decrease
occur in a particular installation. If this
the resources required to make new
equipment does cause harmful
products and avoid using up landfill
interference to radio or television
space. Please do your part by keeping
reception, which can be determined by
this product out of the municipal waste
turning the equipment off and on, the
stream! The "wheelie bin" symbol means
user is encouraged to try and correct
that it should be collected as "waste
the interference by one or more of the
electrical and electronic equipment".
following measures:
FCC INFORMATION
• Reorient or relocate the receiving
This device complies with
antenna.
Part 15 of the FCC Rules.
• Increase the separation between the
Operation is subject to the following
equipment and receiver.
two conditions: (1) This device may not
• Connect the equipment to an outlet
cause harmful interference, and (2) this
on a circuit different from that to
device must accept any interference
which the receiver is connected.
received, including interference that
• Consult the dealer or an experienced
may cause undesired operation."
radio/TV technician for help.
WARNING: Changes or modifications
WARNING: To comply with FCC's RF
radiation exposure limits for general
1
population/uncontrolled exposure, the
antenna(s) used for this transmitter
must be installed to provide a separation
distance of at least 20 cm from all
persons and must not be collocated or
2
5
3
operating in conjunction with any other
antenna or transmitter.
Note: Modifications to this product will
void the user's authority to operate this
equipment.
FCC ID : 2AAJZ-31984X
PACKAGE INCLUDES
1. Product ×1 PCS
4
2. USB charging cable× 1 PCS
3. Instruction booklet×1 PCS
4. Drying agent ×1 PCS
5. Quick guide card×1 PCS
6 7
COMPATIBILITY
Apple: iOS 8.0 and up
BT APP CONTROLLED CAR
Android: Android 4.0.3 and up
CONTROL PANEL
LOCATION OF PARTS AND
CONTROLS
1. Selected
2. Scan list
1. Headlights (2)
3. OK button
2. Wheel (2)
4. Racer's name
3. Wheel (2)
(Click to Change name)
4. Trim Adjustment
5. Turn Right
5. Power Switch
6. Turn Left
6. Charging Port
7. Back
7. Charging LED
8. Straight Backward
9. Straight Forward
10. Low speed
11. Mid speed
12. High speed
13. Input
14. OK button
15. Cancel
1
2
3
11
10
12
4
5
9
6
8
7
13
15
14

Advertisement

loading

Summary of Contents for Brookstone RACER

  • Page 1 • Do not drop or subject to strong Operation is subject to the following equipment and receiver. removal of battery will render product 4. Racer’s name immerse it in liquid. impacts. two conditions: (1) This device may not 3. Wheel (2) inoperative and voids manufacturer •...
  • Page 2: Software Installation

    Merrimack, New Hampshire, USA 03054 • Your device is compatible with BT Right forward SIZE LENGTH: 10CM Rear 2. Tap on your App Racer on your Battery is 4. Can I use multiple BT APP 0-846-3000 • www.Brookstone.com APP CONTROLLED CAR,Please WIDTH: 5CM charging device.