Roland TD-7 Owner's Manual page 92

I Instrument Copy Procedure
(D Select the Ptttelt Plny screen. then press [EDIT].
I t =:1Et:~ IT 1 : ~ F'l3lTt'jIH ttt-415T
F'""'-- 7' ' 7 APP ll
® Move the cursor to I "L3 F' "1". then press [ENTER].
® Move the cursor to "COPY or EXCHANGE", then select either with the [DATA] clittl.
@ Move the cursor, then select F (Factory Preset Instruments) or l..| t User Instrttntents)
@ Move the cursor to the source number field, then select the source Instrument Number with the
[DATA] dial.
If you wish to restore ttll User Instnttnent data to Fttctoty Presets, select FF'I:I1 1 using the [DATA]
dial
@ Move the cursor to the destination number field. then select the tlestimttinn Instrument Number
with the [DATA] dittl.
"'F"t'H !"'F"='l"' "
an
Select COPY¢or EXCHANGE
It-lets:ul=IEt-IT :::ot=~
s=Fs11 ~+o=s12?
IT
Instrument Number
Select Preset or User Instruments
® Press [ENTER].
The screen responds with l:lt"'*E' '-31211.4 25- t.It"1E' '5'
Press [ENTER] to copy.
To cancel copying, press [EXIT].
=t=
=l=
=I=
When you have setected
COPY, you can select a
Factory Preset Instru-
ment (F1 -F512) or User
Instruments (U1~U512)
as the source Instrument.
Only a User Instrument
can be used as a
destination.
When you have selected
EI='=IiIIHt3tI-II3E, only User
Instruments can be
assigned to Ins.
If you select Fe-Fill tn
step <5), the destination
lnstru-ment Number is
selected; l_lr"~|3l11. (You
cannot select the desti~
nation Instrument Num-
ber).
' ' _?: _ 1-at __ ___ _ ;: 1;'; ;;_—_:;—— 7; ____:____ _ — — _— ———— ___ _ __—7_ 7 _ _ — _ _ _ _ _ _ _ _ WW7' 7: ~i::_ __ _— ___ ___ ___ _____ 7 ___ iiflfii
Chapter '4 Editing Instrument Sounds