Oppo BDP-103 Installation Manual page 3

Please update your player to the latest official firmware from Oppo. Check that the
firmware version is BDP10X(EU)-38-1211 or newer. You can check the firmware version
by going to the setup menu, and then selecting Device Setup - Firmware Information.
Also, please make sure to set the Standby mode to "Energy Efficient" in Device Setup –
Standby mode.
How to use the mod (older revisions of Oppo firmware):
By default, your bluray player is now region free for DVD. To set the bluray region to A,
B or C, please press "1", "2" or "3" on the remote when the player is in standby. The
player will automatically power on, when "1", "2" or "3" is pressed. The selected region
will be stored and remembered, even when removing the mains supply from the player.
To disable the automatic power on, press the blue button on the remote once.
To enable automatic power on again, press the yellow button once.
If the player does not power up with the press of the "1", "2" or "3" buttons on the
remote, use the following method:
How to use the mod (for all revisions of Oppo firmware).
Wait for the Home Menu, (if powered up from standby.)
Please remove the disc, if any, and close the tray again.
Now press the setup button to access the setup menu. In the setup menu, press:
X (CLEAR) – X (CLEAR) – Region (1, 2 or 3)
When these keys are pressed, the player will power off in about 1-2 seconds. The region
will have changed, once the player is powered up again.
With the installation done - please check the user manual for special features of the
regionfree kit.