Panasonic WJ-MPU955 Operating Instructions Manual page 49

G Pan/Tilt Control
(Program Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the position to be preset by mov-
ing the Joystick Controller and pressing the lens control
buttons.
3. Select the desired preset position number by pressing
the numeric buttons.
4. Holding down the [PROGRAM PRESET] button, and
then press the [CAMERA (ENTER)] button to save a
preset position of the selected camera.
T&D CAM ID
AUX1 OFF AUX1 ON
ALM S
MON STATUS
AUX2 OFF AUX2 ON
ALM H
DEF OFF DEF ON
SHIFT
Notes:
• If the position number entered has been stored
previously, the old position will be overwritten by
the new one.
• This function is disabled when the WV-CS600
Series or WV-CS650 Series Camera is connected
to the Encoder.
PROGRAM
PRESET
GEN
WIPER
VLD S SYS S
ALL
CALL
PRESET
VDL H
CLEAR CAMERA
( ESC )
( ENTER )
BLK EXIT
AUTO
PAN
G Pan/Tilt Control (Call Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the preset position number by pressing the
numeric buttons.
3. Press the [CALL PRESET] button to move to the pre-
set position of the selected camera on the active moni-
tor.
T&D CAM ID
AUX1 OFF AUX1 ON
ALM S
MON STATUS
AUX2 OFF AUX2 ON
ALM H
DEF OFF DEF ON
SHIFT
Note: To be able to use the above function, the preset
position number must have been set for that cam-
era.
PROGRAM
PRESET
GEN
WIPER
VLD S SYS S
ALL
CALL
PRESET
VDL H
CLEAR CAMERA
( ESC )
( ENTER )
BLK EXIT
AUTO
PAN
49