Set The Channel; Set The Code; Call Tone; Set The Call Tone - Motorola TALKABOUT T5200 User Manual

Set The Channel:

1. With radio on, press Menu button, Current channel
will begin to flash. Figure 5.
2. Use Scroll buttons to change channel while flashing.
3. Press Menu or Push-To-Talk button to set new
channel.
Set The Code: (T5200 only)
1. With radio on, press Menu button twice.
Current code will begin to flash.
2. Use Scroll buttons to change code while flashing.
3. Press Menu or Push-To-Talk button to set new code.
Note: Radio automatically saves channel (and code for T5200) after 5
seconds.

Call Tone:

The Call Tone get's other's' attention before you start talking. Press Call button
and users on your channel will hear your Call Tone. T5100 has a single Call
Tone, while the T5200 has 5 Call Tones.
Set The Call Tone (T5200 only)
Menu
1. With the radio on, press button three
times. Current Call Tone will begin to flash.
Fig. 6.
Scroll
2. Use buttons to change and hearCall
Tone while flashing.
Menu Push-To-Talk
3. Press or button to set
new Call Tone.
6

"Roger" Beep:

Whenever you turn on the "Roger" Beep feature, your two- way radio transmits
a unique tone when you finish transmitting. It's like saying "Roger" or
"Over" and lets others know you're finished talking. If you don't hear ________
or, you can enable it by pressing and holding
your radio. Now, whenever you release the Push-toTalk button, you let your
friends know you're finished talking by transmitting a tone. To disable the
"Roger" Beep feature, turn your radio off and then back on while pressing and
Figure 5
holding Scroll +

Sending Messages:

1. To maximize clarity, hold radio 2 to 3 inches from mouth.
2. Press and hold
Indicator Light glows continuously when transmitting.
3. To receive messages, release

Battery Meter

The Battery Meter, located on the front display, is divided
into three bars. As power is used, the bars will disappear.
Figure 4.
Note:
To ensure proper functioning of the battery meter
use only alkaline batteries. The meter will not work
accurately with rechargeable batteries.

Low Battery Alert:

When batteries are low, radio will beep:
• 3 to 4 seconds after turning power on
Figure 6
• Every 10 minutes in standby mode
• After releasing PTT or Call button
Replace batteries immediately to avoid interrupted use.
Note: Remove batteries before storing your radio for extended periods. Batteries
corrode over time and may cause permanent damage to your radio.
T5100 Series Canada and US
Scroll + button
button. The "Roger" Beep icon will not appear on the display.
Push-To-Talk
button and speak into microphone. LED
Push-To-Talk
button.
as you turn on
Figure 4
7