Advertisement
4. Web Login
A
computer
with
wired
WNAP-C3220 is required for the first-time configuration.
Step 1: Set your computer to a static IP address.
(Following steps are based on Windows 7)
1. Click "Start" button located at lower-left corner of you
computer
2. Click "Control Panel"
3. Double click "Network and Sharing Center" icon
4. Click "Change adapter settings"
5. Double click "Local Area Connection"
6. Select "Internal Protocol Version 4 (TCP/IPv4)"
and click "Properties"
7. Select "Use the following IP address"
8. Assign a static IP address to your PC which should be
in the same network segment with the WNAP-C3220.
As the default IP address of the WNAP-C3220 is
192.168.1.1, you may choose from 192.168.1.2 to
192.168.1.254. Then click OK.
Step 3: When you enter into the Web User Interface,
click Setup Wizard at the left hand side of the
screen.
Step 4: Once the basic configuration of the AP is done.
Click Save button to make the change take
effect.
Ethernet
connection
to
– 5 –
– 7 –
Step 2: The Web management allows you to access and
the
The default User name and Password are both "admin".
Then click OK button to continue.
Default IP Address: 192.168.1.1
Default Username: admin
Default Password: admin
Default SSID: default
5. Wireless Network Connection
Step 1: Right-Click on the network icon displayed in the
Step 2: Highlight the wireless network (SSID) to connect
Step 3: Enter the encryption key of the Wireless Access
FURTHER INFORMATION
The
above
configurations for WNAP-C3220. For further configurations of
different operation modes, please refer to the user's manual in
the CD. If you have further questions, please contact the local
dealer or distributor where you purchased this product.
manage the Wireless AP easily. Launch the Web
browser and enter the default IP address
http://192.168.1.1
– 6 –
system tray.
and click [Connect].
Point.
steps
introduce
simple
– 8 –
installations
and
2011-E10400-000
Advertisement
