Planet Networking & Communication WNAP-3220 Quick Installation Manual

802.11n Wireless Ceiling Mount
300Mbps
WNAP-C3220
Range Extender / Access Point
1. Package Contents
Thank you for choosing PLANET WNAP-C3220. Before
installing the AP, please verify the contents inside the
package box.
Wireless AP Quick Guide
Ethernet Cable Power Adapter
If there is any item missed or damaged, please
contact the seller immediately.
Note
3. Hardware Installation
Step 1: Attach the bracket to the wall or ceiling, and
mark each point in the bracket for the screws.
Remove the bracket to drill the points and insert
the plastic wall-mounts. Use screws to lock the
bracket by a screw driver.
Step 2: Plug the RJ-45
WNAP-C3220.
CD-ROM
Mounting Kit
x 4 x 4
– 1 –
Ethernet cable into
– 3 –
2. Physical Installation
Front Panel Description
Rear Panel Description
1 x 10/100/1000Mbps PoE LAN Port
Step 3: Plug the power adapter into the WNAP-C3220.
Step 4: Attach the
the
Note
Reset Button
Power Connector 12V DC Input
– 2 –
If WNAP-C3220 is connected to a 802.3af PoE
switch in STEP 2, you don't have to plug the
power adapter.
Step 5: Successful
WNAP-C3220 to the
mounting bracket.
1. ONLY use the power adapter supplied with
WNAP-C3220. Otherwise, the product may be
damaged.
2. For the power supply of WNAP-C3220, you
could use either IEEE 802.3af PSE device or
12VDC Adapter. Please do not use 12V
adapter and PSE devices at the same time. It
may damage the WNAP-C3220 itself.
– 4 –
Power LED
installation.