Haier H2F-220WSAA Instructions For Use Manual page 12

FUNCTIONS
Use information
LID OPENING
To open upper lids, lift them slightly and turn inside out.
Open the lid to put the food into the drawer.
Close the lid to avoid contact with the door.
The lid can be removed to increase storage space.
NOTE: Two layers in the upper are furnished with lids, but no food placement
is allowed in the front part of the glass plate; or otherwise lids may fail to be
closed, and if so, please check the food items, adjust their locations, and then
re-close the lids. Warning: check if the lids are closed before shutting the
door, and be sure to shut the door after the lids are properly closed so that no
squeezing on the lids may occur.
REMOVING DRAWERS
Pull the drawers out fully, then lift them up slightly in order to remove.
Drawers (except the bottom drawer) can be removed in order to obtain
increased storage space.
Slides available for some models.
SUPER STORE DRAWER
Pull super store drawer out fully. Lift and pull it out of telescopic guides.
NOTE: Some models of the large drawer are set with slide structure. Proper
way of drawer removing: first, take the food away from it and push it to the
end; then lift its rear part and pull it out. Don't lift the drawer up until it is
blocked, then it can be taken out easily; but if so failed , push it to the end
and repeat the steps again.
ICE CUBES PRODUCTION
Some models are equipped with an ice system including ice cube trays with
removal device and ice bin.
Remove ice trays
Clean and fill with waterRefit ice trays on its support.
Wait for a few hours for the ice to be ready, then turn the knobs to extract the
ice cubes.
The ice cubes will fall directly into the ice container.
Boxes on the door may contain a packed PIZZA with a thickness of less than
30mm or other thin packaged food.
Eutectics available for some models. You can also buy eutectics and put them
in the freezer, and the thickness of the eutectics shall be less than 30mm.
11