Advertisement
®
The EPA certified RBRC
Battery Recycling Seal on the nick-
el-cadmium (Ni-Cd) battery indicates Remington is voluntarily
participating in an industry program to collect and recycle
these batteries at the end of their useful life,when taken out
of service in the United States or Canada.The RBRC
gram provides a convenient alternative to placing used Ni-Cd
batteries into the trash or the municipal waste stream,which
may be illegal in your area.Please call 1-800-8-BATTERY
for information on Ni-Cd battery recycling and disposal
bans/restriction in your area.Remington involvement in this
program is part of our commitment to preserving our environ-
ment and conserving our natural resources."
Trimmer
Actuating
Button
PLEASE NOTE: Before your first use, you may notice what appears to be small particles of white or gray dust on the foil and in or
around the area of the cutter assembly. The particles are from a coating of Molybdenum lubricant which is applied to the new foil and
cutters to provide you with extra smooth optimum shaving performance.
®
pro-
Head
Assembly
™
Pop-Out Trimmer
GREEN
(Charging)
Indicator Light
Headguard
Single
Flexible Foil
Head
Removal
Tabs
ON/OFF
Button
Locking Bar
ON/OFF
Button
(Model SF-3)
Cleaning Your Shaver
TO ASSURE SMOOTH, EFFICIENT PERFORMANCE,
IT IS IMPORTANT TO CLEAN YOUR SHAV E R .
C A U T I O N: Do not remove or replace the head
assembly while shaver is
running as it may cause
damage to the unit.
After each shave, turn
o ff shaver and re m o v e
the head assembly by
grasping the head
removal tabs on both
sides of head assembly
between thumb and fore-
finger and pull straight
u p w a rd to re m o v e .
Holding the cutter as
shown, brush and blow
out the hair clippings
f rom the cutter. Lightly
tap base of head assem-
bly on a flat s u rface. Do
not remove scre e n
assembly from head
a s s e m b l y. Do not use
cleaning brush on
s c reen as it may dam-
age it. When re p l a c i n g
head assembly do not
p ress or touch the
s c re e n .
To avoid possible
damage, it is not re c o m-
m e n ded to remove the
cutter assembly except
for re p l a c e m e n t .
H o w e v e r, if necessary to
remove the cutter
a s s e m b l y, grasp cutter between thumb and fore f i n-
ger and gently lift upward to re m o v e cutter fro m
oscillator tip. Please note the spring seated on the
Advertisement
