3Com 2940, 2941 Install And Operation Instructions page 17

securely stack your cable modem with the
OfficeConnect unit(s). If possible, your
cable modem should always be the top unit
in a stack with OfficeConnect products.
Small hubs are the only units that should be
clipped to the top of a cable modem. Follow
these instructions to clip your modem to an
OfficeConnect unit.
1. Place the OfficeConnect device you
want at the bottom of the stack on a flat
surface. The supplied blue clips fit in the
positions on the side of the unit as shown
in step 1 of the illustration on the next
page.
2. Position a clip over one of these holes
and push it in until it clicks into place, as
shown in step 2 of the illustration on the
next page. Repeat this for the other clip
position on the same side.
14
H S I
ARDWARE AND OFTWARE NSTALLATION
3. Keeping the front of the units aligned,
position the top-most OfficeConnect
device and rest the bottom of the device
on the clips' spikes, as shown in step 3 of
the illustration on the next page. Push
the clips firmly until they click into
place.
NOTE:
units firmly with one hand and hook the
first finger of your other hand around
the back of the clip. Be careful not to
pull so hard that you break the clip.
4. Repeat these steps to secure the other
side.
5. Turn to "Connecting the Cable Modem
to Your Computer" (page 15).
To remove a clip, hold the