FPI FireGenie Installation & Operation Manual page 16

Remove Control witch from Remote
1)
Receiver by pulling out gently.
Remove spring loaded Battery Pack by
2)
pushing in and then pulling out.
Remove Receiver from Bracket and discard
3)
bracket. (This Bracket is no longer required
after this step.)
OTE: After this step, installation of the E21
differs from the rest of the units. Please follow
steps specified for the E21.
Place Heat hield over Receiver. Be careful
4)
not to crimp wires under edge of hield.
ecure Heat hield onto Receiver with 2 x
)
#10 x 1/2" screws. Ensure the bottom of the
Heat hield is flush with the Receiver as
shown in the diagram below.
Re-install Battery Pack and Control witch
6)
by reversing steps 2 and 1 only.
TM