Safety Systems - Bosch MUM6N1 series Repair Instructions

5.2

Safety systems

5.2.1 Safety lock
The appliance is equipped with a safety lock.
It can only be switched on if either the protective cover or the blender
with a locked lid is on the blender drive.
The protective cover or slide switch in the blender handle operate a
switch that interrupts power supply to the motor.
5.2.1.1 Protective cover
1.
58300000129491_en_a.doc – 04.04.08
If the blender drive is not needed, it
is to be covered with the protective
cover.
To use the blender remove the
protective cover from the blender
drive first. To do this, press the back
of the protective cover and remove
the cover.
5.2.1.2 Safety lock for blender
Attach the blender and rotate all the way in an anti-clockwise
direction.
Ensure that the marks on the blender and appliance are in alignment.
The lug on the blender cover must be fully located in the slot in the
blender handle.
Blender will not work unless the cover has been attached and locked.
3.
2.
4.
Seite 13 von 24