Yaesu FT-60R Quick Manual page 11

Richard Barr Hibbs, P.E.
ii. PRESS and HOLD either the [▲MHz] or [▼MHz] key
for one second to initiate scanning.
b. Disabling Memory Scanning.
•
PRESS the PTT switch.
2. Memory Bank Scanning.
To scan ONLY the channels stored in a specific memory bank:
a. Enabling Memory Bank Scanning.
i. PRESS the [V/M] key as necessary to enter Memory mode.
ii. PRESS and HOLD the [BANK] key for one second, then
ROTATE the DIAL knob to select the desired memory
bank.
iii. PRESS the [F/W] key to select the bank for scanning.
iv. Repeat steps ii and iii to include any other desired memory
banks in the scan list.
v. PRESS and HOLD the [V/M] key for one second to start
scanning the selected memory banks.
b. Disabling Memory Bank Scanning.
•
PRESS the PTT switch.
P CW I
ROGRAMMING THE
This feature has several uses for identifying your radio in an emergency.
1. PRESS the [F/W] key, then PRESS the 0[SET] key to enter set
mode.
2. ROTATE the DIAL knob to select Item 11: CW WRT.
3. PRESS the [F/W] key momentarily to display any prior call sign.
4. PRESS the [F/W] key AGAIN to clear any previous call sign.
5. ROTATE the DIAL knob to select the first character of your call
sign, then PRESS the [F/W] key momentarily to save the first
character and move on to the next.
6. Repeat Step 5 as needed to enter your entire call sign. If you make
an error, press the [▼MHz] key to move back to the prior character.
7. If your call sign is 5 characters or less, PRESS and HOLD the
[F/W] key for one second to store the call sign.
8. PRESS the PTT switch to save the call sign and exit to normal
mode.
9. PRESS the [F/W] key, then PRESS the 0[SET] key to enter set
mode.
10. ROTATE the DIAL knob to select Item 10: CWID, then PRESS the
[F/W] key to enable setting this item.
11. ROTATE the DIAL knob to set item to "TX ON."
12. PRESS the PTT switch to save the setting and exit to normal mode.
July 10, 2011
(KI6AQW)
DENTIFIER
FT-60R Quick Guide
Page 9