Icom MXG-5000S Instructions

FCC INFORMATION
This equipment has been tested and
found to comply with the limits for a Class
A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference
to radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case
the user will be required to correct the
interference at his own expense.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications to
this device, not expressly approved by
Icom Inc., could void your authority to
operate this device under FCC regulations.
Icom, Icom Inc. and the Icom logo are registered
trademarks of Icom Incorporated (Japan) in Japan,
the United States, United Kingdom, Germany, France,
Spain, Russia, Australia, New Zealand, and/or other
countries.
MarineCommander is a trademark of Icom
Incorporated.
ABOUT CE AND DOC
Hereby, Icom Inc. declares that
the versions of MXG-5000S
which have the "CE" symbol on
the product, comply with the
essential requirements of the Radio Equipment
Directive, 2014/53/EU, and the restriction of the
use of certain hazardous substances in
electrical and electronic equipment Directive,
2011/65/EU. The full text of the EU declaration
of conformity is available at the following
internet address:
http://www.icom.co.jp/world/support/
DISPOSAL
The crossed-out wheeled-bin
symbol on your product,
literature, or packaging
reminds you that in the
European Union, all electrical
and electronic products,
batteries, and accumulators
(rechargeable batteries) must be taken to
designated collection locations at the end of
their working life. Do not dispose of these
products as unsorted municipal waste.
Dispose of them according to the laws in your
area.
Icom is not responsible for the destruction,
or damage to, or performance of any Icom
or non-Icom equipment, if the malfunction
is because of:
• Force majeure, including, but not
limited to, fires, earthquakes, storms,
floods, lightning, other natural disasters,
disturbances, riots, war, or radioactive
contamination.
• The use of Icom products with any
equipment that is not manufactured or
approved by Icom.
– 4 –
INSTRUCTIONS
GPS RECEIVER
MXG-5000S
PRECAUTIONS
CAUTION: NEVER immerse the GPS
receiver in water. The GPS receiver meets
IPX6 requirements for high-pressure water
jet resistance. However, once it has been
dropped, high-pressure water jet resistance
cannot be guaranteed because of possible
damage to its case or the waterproof seal.
DO NOT use or place the GPS receiver in
areas with temperatures below –20°C (–4°F)
or above +60°C (+140°F).
DO NOT use harsh solvents such as Benzine
or alcohol to clean the GPS receiver, as they
will damage the receiver's surfaces.
The GPS receiver is only for the specified
Icom equipment such as MarineCommander™
or MA-500TR! — Other manufacturer's
equipment may have different pin
assignments and can damage the equipment
or GPS receiver if attached.
SPECIFICATIONS
• Power source voltage: 4.75 to 5.25 V DC
(supplied from the connected equipment)
• Operating temp. range: −20˚C to +60˚C,
−4˚F to +140˚F
• Relative humidity: Less than 95%
(at +35˚C, +95˚F)
• Dimensions: 78(d) × 96.5(H) mm,
3.1(d) × 3.8(H) inch
• Weight (approximate): 460 g, 1 lb
• Cable length (approximate): 10 m, 32.8 ft.
All stated specifications are subject to change without notice or obligation.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan.
Thank you for choosing this Icom product.
READ ALL INSTRUCTIONS carefully
and completely before using this product.
EXPLICIT DEFINITIONS
WORD DEFINITION
Equipment damage may
CAUTION
occur.
Recommended for optimum
NOTE
use. No risk of personal injury,
fire or electric shock.
SUPPLIED ACCESSORIES
Item Quantity
q Hose clamp (HAS-40) ..............................2
w Extension pipe (2273 pipe) ......................1
q w
• Receive frequency: 1575.42 MHz
• Receive channels: 66 channels
• Receive codes: L1, C/A-code, SPS
• Satellite differential type:
WAAS, EGNOS, MSAS,
GAGAN
• TTFF (Time to First Fix):
40 seconds (typical)
– 1 –
A7149H-1EX-3 Printed in Japan
© 2014–2018 Icom Inc.