Formatting The Main Display; Setting A Security Code - Emerson Rosemount 1066 Instruction Manual

1066 Transmitter Instruction Manual
LIQ_MAN_1066-P-FF
6.4

Formatting the Main Display

The main display screen can be programmed with the Transducer Block in the Automatic Mode
as follows:
1. Press MENU
2. Scroll down to Display. Press ENTER.
3. Main Format will be highlighted. Press ENTER.
4. The sensor 1 process value will be highlighted in reverse video. Press the selection keys to
navigate down to the screen sections that you wish to program. Press ENTER.
5. Choose the desired display parameter or diagnostic for each of the four display sections in
the lower screen.
6. Continue to navigate and program all desired screen sections. Press MENU and EXIT. The
screen will return to the main display.
6.5

Setting a Security Code

The security codes prevent accidental or unwanted changes to program settings, displays, and cal-
ibration, by using 3 digit security codes. The 1066 has two levels of security to control access and
use of the instrument to different types of users. The two levels of security are:
• All: This is the supervisory security level. It blocks access to all menu functions, including
Programming, Calibration, and Display.
• Calibration: This is the operator or technician level menu. It allows access only to calibration.
To turn off either security code, simply enter '000'.
To access Security, select Program and then scroll down to and select Security.
FIGURE 6-1. Display Formatting in AMS using Fieldbus
Display and Operation
Section 6: Display & Operation
September 2013
27