Cisco NCS 4200 Series Configuration Manual page 9

Configuring SDH
Configuring AUG Mapping
This section describes the configuration of Administration Units Group (AUG) mapping.
Configuring AU-3 or AU-4 Mapping
To configure AU-3 or AU-4 mapping:
configure terminal
aug mapping [au-3 | au-4]
end
The aug mapping command is available only when SDH framing is configured.
Note
Note The AUG mapping mode is AU-4 by default. AUG mapping is supported at STM-1 level.
Configuring Mixed AU-3 and AU-4 Mapping
To configure mixed AU-3 and AU-4 mapping:
configure terminal
aug mapping [au-3 | au-4] stm [1-1] stm1 number [1-4]
end
Use the following command to change the AUG mapping of a particular STM-1 to AU-3:
Note
aug mapping au-3 stm [1-16] path number 1-16
After configuring this command for STM-4 the AUG mapping of path 2, 3, and 4 is AU-4 and for path 1
it is AU-3.
Verifying AUG Mapping Configuration
Use show running-configuration command to verify the AUG mapping configuration.
show running-config | sec 0/3/4
PDT: %SYS-5-CONFIG_I: Configured from console by console
controller MediaType 0/0/16
mode sdh
controller SDH 0/0/16
rate STM4
no ais-shut
alarm-report all
threshold sf-ber 3
clock source internal
overhead s1s0 0
aug mapping au-4 stm 1
aug mapping au-3 stm 2
aug mapping au-4 stm 3
aug mapping au-4 stm 4
au-4 1
1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
Configuring AUG Mapping
IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
9