Cisco NCS 4200 Series Configuration Manual page 10

Configuring Modes under AU-4 Mapping
!
au-3 4
!
au-3 5
!
au-3 6
!au-4 3
!au-4 4
!
Configuring Modes under AU-4 Mapping
This section describes the configuration of modes under AU-4 mapping.
Configuring Mode VC-4 CEP
To configure mode VC-4 CEP:
enable
configure terminal
controller sdh 0/0/16
rate stm 4
aug mapping au-4
au-4 1
mode vc4
cem-group 100 cep
end
Overhead C2 should match with the peer end else it will result in PPLM alarm.
Note
Verifying Mode VC-4 Configuration
Use the show running-configuration command to verify the mode VC-4 configuration.
#show running-config | sec 0/3/4
PDT: %SYS-5-CONFIG_I: Configured from console by console
platform enable
controller MediaType 0/0/16 oc12
controller MediaType 0/0/16
mode sdh
controller SDH 0/0/16
rate STM4
no ais-shut
alarm-report all
threshold sf-ber 3
clock source internal
overhead s1s0 0
aug mapping au-4
au-4 1
mode vc4
clock source internal
au-4 2
!
au-4 3
!
au-4 4
1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
10
Configuring SDH