Initial Setup; Select A Language; Automatically Searching For Channels - RCA TV/VCR User Manual

Connections & Setup

Initial Setup

The first time you turn on your TV/VCR, you'll be asked to set a few screens so that your TV/VCR will be set up
correctly. Complete the following steps to set up your TV/VCR.
SELECT LANGUAGE
ENGLISH
ESPANOL
FRANCAIS
SELECT /
CONNECT ANTENNA
START AUTO CH PRESET?
YES
NO
PLEASE WAIT
AUTO PROGRAMMING
AIR 2
12

Select a Language

The first time you turn on the TV/VCR, the SELECT LANGUAGE menu appears
on the screen. If you want the on-screen menus to appear in English, press the
OK button on the remote control. If you want the on-screen menus to appear
in a different language, follow these steps.
1. Press the down arrow on the remote to highlight ESPANOL (Spanish) or
: SET OK
FRANCAIS (French).
2. Press OK to select the language.
Note: If you need to change the language later, you can access this menu
from the Main menu - go to page 37 for instructions.

Automatically Searching for Channels

The next part of the initial setup asks you if you want to start AUTO CH PRESET
(also called auto programming or auto channel search) – this enables the
OR CABLE.
TV/VCR to search for all of the channels that are viewable through your cable
TV connection or off-air antenna.
1. If you've connected your antenna or cable, press the OK button on the
OK
remote (auto programming starts).
MENU
When the search is complete the TV/VCR will automatically tune to the first
channel in the channel list.
To stop, press the OK button on the remote control.
STOP OK
Chapter 1