RCA HDTV User Manual page 27

Tips
The component button corresponding to the
mode you're in fl ashes when the remote bat-
teries are low and you press a button on the
remote. Also, a message might appear on the
TV screen and disappear within a few seconds.
Press CLEAR and replace the batteries to re-
move the message.
To turn off most RCA components that are
connected to the TV, press ON•OFF twice within
two seconds and hold remote steady until indi-
cator turns off.
OK When a menu item is highlighted, press OK to select the item.
ON•OFF Turns the TV on or off. Your HDTV is equipped with a special lamp system. In order
to preserve the life of the lamp, the TV must warm up and cool down properly when you turn
the TV on and off. When you turn the TV off, the screen turns blue and fades to black. While
the screen is blue, you can still turn the TV back on. If the screen is black when you try to turn
it on, the TV's lamp is in its cool-down cycle. The TV's audio comes on, then the picture is
displayed after a few moments.
In other modes (VCR, DVD, SAT•CABLE, AUX•HD, AUDIO), and if programmed, turns the
component on and off.
PRESETS Toggles through the Picture Presets for the input currently tuned to. The preset is
only temporarily changed and goes back to the original menu setting when you change channels
or inputs or turn off the TV.
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides transport
control for some remote-controllable VCRs and DVD players.
SAT•CABLE (Satellite•Cable) Places the remote in SAT/CABLE box mode. If Auto Tuning
is enabled, turns on the TV and tunes it to the satellite or cable box Video Input Channel. This
button lights when you press a valid button in SAT•CABLE mode (see Modes of Operation on
page 28 for more details).
SKIP Press once before changing channels and the TV returns to the original channel after 30
seconds. Press repeatedly to add more time. Press CLEAR to cancel.
SOUND On digital channels/inputs, toggles through the audio modes (if available for that
channel). For analog channels, toggles SAP on or off. If you change channels/inputs, the default
for Audio Mode is restored. Does not affect default menu settings for SAP or Audio Mode.
TV Places the remote in TV mode. Turns on the TV and tunes to the last-viewed TV channel or
input. This button lights when you press a valid button in TV mode (see Modes of Operation on
page 28 for more details).
VCR Places the remote in VCR mode. If Auto Tuning is enabled, turns on the TV and tunes to
the VCR Video Input Channel. This button lights when you press a valid button in VCR mode
(see Modes of Operation on page 28 for more details).
VOL – or VOL + Decreases or increases the TV's volume. The TV Audio Output menu must be
set to Variable Level, Speakers On to control the TV's volume.
Chapter 2
Using the Remote Control
INFO Brings up the Channel Banner with channel and viewing information.
Press again to remove the banner.
INPUT Toggles through the TV's available input sources (INPUT 1, INPUT 2,
INPUT 3, INPUT 4, Front Input, HDMI/DVI, and last-active channel). To quickly
access an input, press the INPUT button and the input number, for example,
INPUT + 1 to access INPUT 1.
MENU Makes Main Menu appear and disappear.
MUTE Reduces the TV's volume to its minimum level. Press again to restore
volume. The Audio Output menu must be set to Variable Level, Speakers On to
control the TV's volume.
25