Table of Contents
Advertisement
RS2610-EN rev.1
7/23/02
Getting Started
Unpacking the system:
EN
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one FM antenna wire;
• one AM loop antenna;
• one user's guide;
• one safety leaflet;
• Owner and registration Card
Back View
6
~
1. FM Antenna
2. AM Loop Antenna Jack
3. AUX IN Connector
4. Surround Speaker Jacks
5. Main Speaker Jacks
6. Voltage Selector
Using the FM and AM Antennas
Before you use your audio system, you'll want
to make sure the FM antenna is positioned
properly. Connect the FM antenna to the FM
connector on the back of the unit. Uncoil it,
making sure it is fully extended (you may even
want to tape it to the wall behind the unit, if
possible. The higher, the better.)
You'll also need to connect the AM antenna
loop to the back of the unit if you listen to
AM stations. Rotate the AM loop antenna for
better reception.
2
3:11 PM
Page 6
Connecting the Speakers
Match the red wire (on the left speaker) to red
terminal for the left speaker (L) on the back of
the unit and the black wire (on the left speak-
er) to the black terminal for left speaker (L).
Follow the same procedure to connect the
right (R) speaker.
Antenna and Speaker Wire Connection
1
2
Installation
AUX IN
3
To ensure sufficient ventilation, keep the spacings
R
L
_
_
shown below free from other surfaces:
4
R
+
+
L
+
5
+
Push terminal tab down to
Release tab to lock wire in
insert wire.
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the Antenna and speaker wires at all connection
points.
4 inches
4 inches
1/2
Front View
4 inches
2 inches
Side View
4 inches
Advertisement
Table of Contents
