Table of Contents
Advertisement
OPERATION
TAPE
MONITOR
AUX
POWER
Warning: To prevent possible hearing loss, turn
before you turn on the receiver or change the program source. After
you turn on the receiver or change the program source, adjust
to a comfortable listening level.
VOLUME
You can use the supplied remote control by pointing it at the
receiver's front panel and pressing the desired button(s). Many
buttons on the remote control work the same as buttons on the
receiver's front panel. Use these buttons exactly as you would use the
corresponding buttons on the receiver.
1. Press
to turn on the receiver. It takes about 5
POWER
seconds to hear sound.
2. Select the speakers. An indicator lights next to the
show which speakers are on.
If you connected speakers only to the
terminals, press
SPEAKERS A
speakers. Do not press both
so turns off all speakers even though both indicators are on.
If you connected speakers to both the
terminals, you can:
• Press
SPEAKERS A
for a two-speaker effect.
• Press
SPEAKERS A
for a four-speaker effect.
Press
SPEAKERS A
and/or
listen privately with headphones (see "Using Headphones" on
Page 11).
3. Select a program source.
To tune to a radio station, see "Direct Tuning (Remote Control
Only)" on Page 10.
To listen to signals from the component connected to the
jacks, press
MONITOR
TAPE MONITOR
PHONO
CD
FM
SPEAKERS
PHONES
A/B
VOLUME
A
(or
)
A
B
SPEAKERS
(or
) to turn on only those
B
SPEAKERS A
and
B
because doing
and
A
B SPEAKERS
or
B
to turn on either pair of speakers
and
to turn on both pairs of speakers
B
B
to turn off all speakers so you can
so TAPE MON appears.
AM
TUNING DOWN
TUNING
MODE
FM MODE
to
To listen to a source other than the one connected to the
MIN
MONITOR
disappears. Then press
AUX appears).
4. Turn
VOLUME
counterclockwise to decrease it. Or, you can use
8
and
5. To adjust the tone, turn
increase the high and low ranges of sound at low volume, press
LOUDNESS
6. To adjust the balance of sound between the left and right
speakers, see "Adjusting Balance" on Page 11.
and/or
to
B
7. When you finish using the receiver, press
USING THE SLEEP TIMER
The sleep timer lets you set the receiver to play for up to 90 minutes,
then automatically turns off.
1. To set the timer, turn on the receiver then press
remote control. The display dims and SLEEP 90 SLEEP
appears.
2. To set the sleep timer for less than 90 minutes, repeatedly press
SLEEP
button. Once you select the time, the receiver displays the
program source. (SLEEP stays on the display in small letters
until automatic shut-off.)
3. To briefly see the time remaining, press
TAPE
TUNING UP
PRESET
SCAN
BASS
MEMORY
jacks, press
TAPE MONITOR
,
CD
PHONO
clockwise to increase the volume or
on the remote control.
and
BASS
TREBLE
. (To turn off this feature, press
to decrease the time by 10 minutes for each press of the
VOLUME
LOUDNESS
BALANCE
TREBLE
TAPE
so TAPE MON
, or
(CD, PHONO, or
AUX
9
VOLUME
toward
or
. To
+
–
again.)
LOUDNESS
to turn it off.
POWER
on the
SLEEP
once.
SLEEP
9
Hide quick links:
Advertisement
Table of Contents
