Table of Contents
Advertisement
DTMF Digit Grabbing
The TS52PRO Test Set allows you to capture DTMF
(Dual-Tone Multi-Frequency) tones generated on a
telephone line. This feature is useful when you suspect
that the customer's equipment is not generating
proper DTMF signals. In order to maximize battery life,
the default state is to turn DTMF Digit Grabbing off.
Digit Grabbing is deactivated when the display times
out. To turn it on:
1
Set the Talk/Monitor switch to M.
2
Press the STORE/PROG key.
3
Press the TEST key. The test set gives a
confirmation tone.
Visual ANAC Mode
(For service provider use only, visual ANAC not available
in all regions)
You can get an ANAC (Automatic Number
Announcement Circuit) DTMF response by putting the
test set in visual ANAC mode:
1
Set the Talk/Monitor switch to T.
2
Press the STORE/PROG key.
3
Press the # key. The display shows ANAC MODE.
After you dial the ANAC number and get a response,
the phone number of the line pair that the test set is
connected to is shown on the display. If the ANAC
response is greater than 10 digits, the last 10 will be
displayed. The test set is automatically muted in visual
ANAC mode. If a visual response is not available, an
audible response is given.
You can also enter the ANAC number in speed dial
location 9 and the test set automatically enters Visual
ANAC mode when the speed dial is used. If a visual
response is not available, an audible response is given.
Use one of the other speed dial locations (0-8) if you
always want an audible response.
ANAC mode is turned off when you switch to Monitor
mode. If ANAC mode is off, the ANAC voice response is
audible on the handset or speaker.
Factory Defaults
The Restore Defaults function lets you restore all
programmable features to their original factory
settings. This function does not clear stored telephone
numbers. The defaults are:
•
Hook Flash: 600 ms
•
Speaker timeout: 2 minutes
•
Speakerphone: enabled
•
Receive-Only Loud Speaker: disabled
•
Backlight: off
•
DTMF Digit Grabbing: off
•
Monitor Mode timeout: 2 minutes
To restore the factory default values:
1
Set the Talk/Monitor switch to M.
2
Press the STORE/PROG key.
3
Press the pound (#) key. The test set gives a
confirmation tone when the entry is accepted.
Operation
19
Hide quick links:
Advertisement
Table of Contents
