How To Set The Clock - RCA Scenium L50000 User Manual

5. Once you have selected the FROM MODE component, the display message prompts you to enter the TO
MODE component. Push the desired component button.
6. When a valid TO MODE component is entered, the remote automatically processes the mode reassignment
and SUCCESS appears. The remote will then EXIT SETUP and return to normal operation.
NOTES:
• Press the CLEAR button at any time to exit the programming mode (EXIT SETUP appears and the
remote return to normal operation).
• If any button other than a valid component button is entered, INVALID appears and the remote will
remain in this FROM MODE or TO MODE programming mode until a valid component is entered.
• If about 30 seconds passes before a button is pressed, the remote's display window will stop
transmission to conserve battery life. If this occurs, restart from step 1.

How to Set the Clock

1. Press and hold
2. Step through the programming menu by pressing the down arrow button until CLOCK SET appears in the
remote's display, then press the OK button.
ON•OFF 3. After you press the OK button, the remote will display the hours and minutes.
DIRECTV TV
VCR
DVD
1
4. Use the up arrow button to modify the hours and the down arrow button to modify the minutes.
VCR
AUX
2
AUD
M1 M3 NOTE: To set the AM or PM appropriately use the up arrow button and step through the hours for the
M2
correct setting.
L1 L3
L2
5. Once the time is set correctly, press the OK button to complete the setup (SUCCESS followed by EXIT
FRONT
MUTE SKIP
SETUP appears).
CH +
VOL - VOL +
REAR CENTER
CH -
GO
FORMAT
BACK
TEST AM•FM
GUIDE INFO
Chapter 3
Chapter 3
(the backlight button) until CODE SET appears in the remote's display.
The Remote Control
The Remote Control
57