Fisher & Paykel GWL03US Service Manual page 66

10. Fit the wires to the stator before locating the stator into position. Check that the wiring is
correct – see markings on the stator.
11. Grease the stator side of the clamp plates and around the inside section of the stator that fits
over the bearing, with any multi purpose grease. Fit the clamp plate and spacer assembly to the
back of the stator. Locate the stator into position. Place the motor shield onto the stator, ensure
the 4 buffers tubes are in position on the motor shield. Locate the stator, and motor shield onto
the tub. Check that the bearing drain tube is located in the drain hole in the tub and is clipped
into place on the motor shield. It will only fit in one position.
66