Resetting The Mobile Printer; Cleaning The Printer - Intermec PB50 User Manual

Chapter 3 — Troubleshooting and Maintaining the Mobile Printer

Resetting the Mobile Printer

Cleaning the Printer

60
You rarely need to cold boot the printer, unless you are upgrading the
firmware. If your printer occasionally locks up, you will want to cold
boot it. A cold boot reinitializes the 802.11 radio and clears the
working memory.
Note: The Setup menu is not affected by a cold boot. Your printer
retains all of your configuration settings after the printer powers back
up.
To reset the printer
1 Disconnect the printer from power if externally powered.
2 Remove the battery from the printer for at least one second.
3 Insert the battery back into the printer.
4 Reconnect external power if your printer is externally powered.
To properly maintain your printer, you must clean it at the
recommended interval. Use the following illustration to locate the
parts of your printer to clean.
Make sure to clean the following parts:
Printhead
Platen roller
Paper sensors
Tear bar
Printer exterior
Media compartment
To avoid possible personal injury or damage to the printer, never
insert any pointed or sharp objects into the printer.
PB50 and PB51 Mobile Printer User's Guide