Measurement And Adjustments; Adjustment Procedure Flowchart; Cautions For Adjustment; Setting Before Adjustment - Panasonic PT-AX200U Service Manual

PT-AX200U / PT-AX200E

7 Measurement and Adjustments

7.1.

Adjustment Procedure Flowchart

7.2.

Cautions for Adjustment

· Never turn off the MAIN POWER switch until every fan completely stops.
· To maintain and ensure safety, always use the designated components for replacement parts.
· If removing any clamps, lead wires or connectors, always place them back in their proper locations.
· Be careful not to damage the lead wires or components when using a soldering iron or similar tool.
7.3.

Setting Before Adjustment

· Set up the projector to obtain the projection distance below.
· Turn the zoom ring of the projector to obtain the largest size of the picture.
7.4.

Convergence Adjustment

Execute this adjustment when replacing the LCD panel (B) .
7.4.1. Tools to be used
Service Kit : This kit is composed of 3 extension flexible cables and 4 connector extension cables.
Note:
· Consult your dealer or Authorized Service Center for the service kit.
7.4.2. Preparation
1. Loosen 2 screws fixing the panel adjuster and 3 screws fixing the panel attachment, then tighten the 5 screws temporarily just
until the LCD panel can be shifted by your fingers.
22