Philips MRD200 Service Manual page 16

Dismantling of the Main Board (include Tuner & Surround Board)
1) Loosen 6 screws F on the top of main board as shown in figure 7.
2) Loosen 10 screws C at the back panel as shown in figure 8.
3) Loosen 3 screws D on the bottom cover as shown in figure 9.
4) Remove all connectors on tuner, surround, RGB & main board.
C
D
Figure 9
Dismantling of the Speaker Jack Board & Fan
1) Loosen 6 screws E at the back panel as shown in figure 8.
2) Remove all connectors at speaker jack and Fan.
3-2
E
Figure 8
F
Figure 7
SERVICE POSITIONS
Service position A
Note: In some service positions the components or copper patterns of one board may risk touching its neighbouring pc
boards or metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
Service position C
3-2
Service position B