ADC e-sphyg 2 User Manual page 10

BATTERY MARK flashes in the segment LCD when the battery charge is low.
Only a few more measurements remain before the battery runs down.
The battery needs to be recharged when BATTERY MARK is displayed.
Measurement cannot be made.
NOTE: The rechargeable batteries may not be completely full after their initial charge or
when they have not been used for an extended period of time. This should be solved once
the unit has been used a few times and the batteries have been charged and discharged.
Battery life
Life of the rechargeable NiMH battery is approximately 2 years. However it may vary
depending on operating conditions. Replace the battery when BATTERY MARK is dis-
played often or when frequent charging of the battery becomes necessary.
Tips on prolonging the battery life
The device is powered by the AC ADAPTER when it is connected;
the installed battery is not used if the AC ADAPTER is connected.
• Remove the battery when operating the device with the AC ADAPTER for an ex-
tended period of time or when the battery does not need to be charged.
• Avoid charging the battery if it is not completely exhausted.
Do not forcefully remove the battery or pull out the plugs holding
cords and cables.
Use indicated AC Adapter and the battery only.
Contact your dealer if they are damaged.
POWER MARK
The device goes to energy saver mode when it is left turned on and not operated for
approximately 3 minutes. The mark will be displayed for an hour and then disappear.
Make sure to turn off the device by pressing "
after each use especially when the device is powered by the battery.
The device activates from energy saver mode when either START/STOP button or
SET/MEMORY button is pressed. It is recommended to activate the device by pressing
SET/MEMORY button since the device could start inflation if START/STOP button is
pressed. Press START/STOP button again and stop inflation if the cuff is not wrapped
around arm.
" side of MAIN POWER SWITCH down
10