Disconnecting/Connecting Battery Cables - Invacare 3G Storm Series Torque ST User Manual

9 SETUP/MAINTENANCE

9.12 Disconnecting/Connecting Battery Cables

Group 24 Batteries

For this procedure, refer to FIGURE 4 on page 104 and FIGURE 5 on page 105.
Disconnecting

Perform this section on one battery and battery box at a time. Repeat section for other battery box.
1. Lift up on battery box lid to expose underlying cables.
2. Peel back battery terminal caps to expose battery cable ends as follows:
A. RED battery terminal cap from RED battery cable.
B. BLACK battery terminal cap from BLACK battery cable.
3. Remove the locknut and mounting screw or clamp to disconnect BLACK battery cable from the NEGATIVE(-) battery terminal/post (Detail "A"
of FIGURE 5)
4. Remove the locknut and fuse mounting screw or clamp to disconnect RED battery cable from the POSITIVE (+) battery post (Detail "A" of
FIGURE 5).
Connecting

Perform this section on one battery and battery box at a time. Repeat section for other battery box.
1. Position battery box top above battery as shown in FIGURE 5.
2. Peel back battery terminal caps to expose battery cable ends as follows:
A. RED battery terminal cap from RED battery cable.
B. BLACK battery terminal cap from BLACK battery cable.
3. Install the locknut and mounting screw or clamp to connect the BLACK battery cable to the NEGATIVE (-) battery terminal/post (Detail "A" of
FIGURE 5).
Invacare 3G Storm Series®
102
Part No 1143151