Advertisement

PLT-3043YW
TRIMMER
OWNER'S OPERATION MANUAL
N197

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi PLT-3043YW

  • Page 1 PLT-3043YW TRIMMER OWNER'S OPERATION MANUAL N197...
  • Page 2 Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5...
  • Page 3 Fig. 7 Fig. 6 Fig. 8 Fig. 9 Fig. 10 Fig. 11...
  • Page 4 Fig. 12 Fig. 13 Fig. 15 Fig. 14 Fig. 16 Fig. 17...
  • Page 5 Fig. 18...
  • Page 6 English SYMBOLS Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. EXPLANATION SYMBOLS NAME Indicates danger, warning or caution. it means attention!!! Safety Alert Symbol Your safety is involved.
  • Page 7 SAFETY trimmer, these parts get hot from operation. Always stop the engine and remove the spark plug wire Thank you for buying a Ryobi trimmer. before making any adjustments or repairs except for Your new trimmer has been engineered and carburetor adjustments.
  • Page 8 43. Tabs air filter cover 46. "H" High needle SPECIFIC SAFETY RULES FOR TRIMMER USE 47. Anchor hole 44. Idle speed screw 48. Fuel cap 45. "L" Low needle Maintain a firm grip on both handles while trimming. Keep bump head below waist level. Never cut with the bump head located over 76 cm or more above the ground.
  • Page 9 Carefully pour fuel mixture into the tank. Avoid spillage. OPERATION Prior to replacing the fuel cap, clean and inspect the gasket. Read the operation manual and follow all warnings and safety instructions. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage.
  • Page 10 OPERATION 7. Run engine 15 to 30 seconds at full throttle (with trigger depressed fully) on half choke position ( ) to warm NOTE: If the line is worn too short you may not be able to up. Move choke lever to run position ( ) (16).
  • Page 11 SPARK ARRESTOR MAINTENANCE The spark arrestor must be cleaned or replaced every 25 hours or yearly to ensure proper performance of your 3. To install the new spool, make sure the two lines are product. Spark arrestors may be in different locations captured in the slots (34) opposite each other on the new depending on the model purchased.
  • Page 12 MAINTENANCE STORAGE (1 MONTH OR LONGER) 1. Drain all fuel from tank into a container approved for fuel. Run engine until it stops. 2. Clean all foreign material from the trimmer. Store it in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.
  • Page 13 TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVETHE PROBLEM CONTACTYOUR AUTHORIZED SERVICE AGENT. PROBLEM POS S IBLE CAUSE SOLUTION Engine does not reach full 1. Check oil fuel mixture. 1. Use fresh fuel and the correct 2-stroke oil mix. speed and emits excessive 2.
  • Page 14 In the event of malfunction within the guarantee period, please return the product UNDISMANTLED with proof of purchase, to your dealer or nearest Ryobi Service Centre. Your statutory rights in respect of defective products remain unaffected by the warranty...

Table of Contents