Advertisement
AXI 02 AT Configuration
Renaming the AXI 02 AT
The AXI 02 AT default device name consists of the device model and the last six characters of the device MAC address. When
multiple devices are on the network with default device names, identifying a specific device is difficult. To avoid confusion when
multiple devices are on a network, Extron strongly recommends renaming each device with a unique and meaningful identifier.
NOTE:
Dante Devices can also be renamed using Dante Controller (see the AXI 02 AT User Guide for more information).
To name the Dante device:
1.
Open DSP Configurator and select Connect... from the splash screen drop-down and click OK.
2.
Select the USB or Dante tab from the Connect to device... dialog, depending on the chosen connection method.
3.
Select the AXI 02 AT being configured from the list of available devices and click OK.
NOTE:
If connecting through the Dante tab, the AXI 02 AT default device
name needs to be known. The AXI 02 AT default device name consists
of the device model and the last six characters of the device MAC
address. The MAC address is located on the white label on the side
of the device (see the image to the right for one example of a default
device name).
4.
Select Tools > Device Settings. The Device Settings dialog box
opens to the Unit Info tab.
5.
Select the Dante Device tab at the top of the dialog box.
Enter a unique and meaningful name for the AXI in the Device Name field. For
6.
example, in the
image
AXI02-Breakout1 to indicate it is located in breakout room #1.
NOTES:
•
Device names cannot be longer that 31 characters, cannot begin or
end with dashes (-), and cannot contain + ~ , @ = { } [ ] < >
" ; :
\ | ' ? ! # $ % _ ` . / ^ or spaces.
•
The name applied in the Device Name field is applied to the Dante
device and is the name that appears in Dante Controller.
Click Apply.
7.
8.
AXI network configuration details can be viewed below the device name in the Dante Device tab.
9.
Click OK to close the Device Settings dialog box.
Additional Configuration
Additional configuration, such as renaming channels and adjusting output attenuation, can be performed with DSP Configurator.
Refer to the AXI 02 AT User Guide for information regarding additional configuration with the DSP Configurator Software.
To route audio across the Dante network and complete other Dante-specific configurations, use Dante Controller (see
Downloading and Installing Dante Controller software on the next page).
on page 5, the AXI 02 AT has been renamed to
3
Advertisement
