Advertisement
Front Panel Features
AXI 02 AT
R
A
D
C
Figure 3.
AXI 02 AT Front Panel Features
Power Indicator LED — This green LED blinks during boot up and lights steadily when the AXI 02 AT is powered and fully
A
operational. This LED also blinks amber for 10 seconds when the device receives a Dante identification signal (see the
AXI 02 AT User Guide for more information on identifying physical Dante devices).
USB Config Port — Connect a computer to this USB Mini-B port for device configuration and firmware updates.
B
AT (PoE) Port — This RJ-45 port is used to connect the AXI 02 AT to a Dante network. The AT (PoE) port supports digital
C
audio transport (AT), communication with the Dante network, communication with DSP Configurator for device configuration,
and power over Ethernet (PoE).
ATTENTION:
•
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected only to networks or circuits that
are not routed to the outside plant or building.
•
L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur uniquement. Elle doit être connectée
seulement à des réseaux ou des circuits qui ne sont pas routés au réseau ou au bâtiment extérieur.
Reset Button — Using a stylus or small screwdriver, press and release this button to reset the unit to different tiers of factory
D
defaults, including Dante settings such as device name, IP address, channel names, and audio format (see the AXI 02 AT
User Guide for more information regarding resets).
DSP Configurator Software Installation
The AXI 02 AT can be configured with Extron DSP Configurator Software using the USB port or AT (PoE) port. Install
DSP Configurator on a PC running Microsoft
at www.extron.com.
Downloading DSP Configurator from the Extron Website
1.
From the Extron homepage (www.extron.com), click the Download tab to open the Download page.
Under Software, on the left side of the page, select DSP Configurator Software. The DSP Configurator Software
2.
product page opens.
3.
Click the Download button and follow the on-screen instructions.
NOTE:
An Extron Insider account is required to download DSP Configurator.
CONFIG
Power Indicator LED
A
USB Config Port
B
B
Windows
. For full computer requirements, see the DSP Configurator product page
®
®
AT (PoE) Port
C
Reset Button
D
2
Advertisement
