Onkyo TX-NR686 Instruction Manual page 96

Setting Item Default Value
Surr Back Left 0 dB
Surround Left 0 dB
Subwoofer 0 dB
„ 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item Default Value
Dolby Enabled 6.0 ft/1.80 m
Speaker to Ceiling
AccuReflex Off
• This setting can be selected when "Configuration" - "Height Speaker" is set to "Dolby
Speaker".
Setting Details
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-15 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
Contents Connections
≫
„ 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to five bands for the Subwoofer and nine bands
for the other speakers.
Setting Item Default Value
Front 0.0 dB
Center 0.0 dB
Height 0.0 dB
Surround 0.0 dB
Surround Back 0.0 dB
96
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
≫