Table of Contents
Advertisement
M A I N M E N U
T I M E R
V I D E O A D J U S T
C O M P O N E N T A D J .
A U D I O A D J U S T
C L O S E D C A P T I O N
P A R E N T C O N T R O L
L A N G U A G E
E N E R G Y S A V E
S E T U P
E N E R G Y S A V E
S T A T U S : O F F
R E T U R N
E N E R G Y S A V E
S T A T U S : O N
R E T U R N
• [ , ] t o m o v e c u r s o r
• [ , ] t o s e t
M A I N M E N U
T I M E R
V I D E O A D J U S T
C O M P O N E N T A D J .
A U D I O A D J U S T
C L O S E D C A P T I O N
P A R E N T C O N T R O L
L A N G U A G E
E N E R G Y S A V E
S E T U P
• [ , ] t o m o v e c u r s o r
• [ O K ] t o s e t
Chapter 4
F27TF12.04 Menu
35
Using the TV's Menu System
The ENERGY SAVE Menu
This feature reduces the brightness of the picture, lowering the power
consumption of your TV/VCR by approximately 20 percent.
1. Press MENU on the remote (the main MENU appears).
2. Press the up or down arrow button to select ENERGY SAVE and press OK.
3. Press the left or right arrow button go back and forth between ON and OFF.
4. Press MENU to exit.
Additional Settings in the SETUP Menu
Most of the options in the SETUP menu were discussed in Chapter 1, but there
are a few other settings within this menu that you can adjust to your personal
preferences.
1. Press MENU on the remote (the main MENU appears).
2. Press the up or down arrow to select SET UP and press OK (the following
choices appear):
UNIVERSAL PLUS This feature is sometimes called auto tuning. The auto-
•
tuning feature automatically tunes the TV to the correct channel for different
components you have connected to your TV (like a VCR or DVD Player,
etc.).
When you set up auto tuning in the Universal Plus menu, you don't have to
remember to change your TV to channel 3, for example, when you want to
watch the tape that's in your VCR. To set up the UNIVERSAL PLUS menu:
1. Since UNIVERSAL PLUS is the first item, just press the OK button on the
remote control (the UNIVERSAL PLUS menu appears).
2. If you've connected a VCR to your TV with audio/video cables (i.e., to a
LINE IN jack on the TV), press INPUT until the corresponding video input
channel appears — LINE 1, LINE2, LINE3, or COMPONENT. If you
connected a VCR to your TV with a coaxial cable (i.e., to the ANT/CABLE
jack on your TV), use the number buttons on your remote to enter the
channel that corresponds to the switch on the back of your VCR (usually
channel 3 or 4).
3. Press the down arrow button to highlight status. Press the left or right
arrow button to switch between ON and OFF.
4. To exit, press MENU.
Continues on next page
7/19/01, 3:38 PM
35
Advertisement
Table of Contents
