Water Drainage - John Lewis JLWM1407 User Manual

1. Connect the water inlet hose to the back of
the appliance.
2. Position it toward left or right depending on
the positon of the water tap. Make sure that the
inlet hose is not in vertical position.
3. If necessary, loosen the ring nut to set it in the
correct position.
4. Connect the water inlet hose to the cold
water tap with 3/4'' thread.

3. Water drainage

The drain hose should stay at a height of not less
than 60 cm and not more than 100 cm.
You can extend the drain hose to
maximum 400 cm. Contact the
authorized service centre for the
other drain hose and the extension.
It is possible to connect the drain hose in
different ways:
1. Make a U shape with the drain hose and put it
around the plastic hose guide.
10
O O
45 45
O O
20 20
2. On the edge of a sink - Fasten the guide to
the water tap or to the wall.
Make sure that the plastic guide
cannot move when the appliance
drains and the drain hose end is not
immersed in the water. There may
be a return of dirty water into the
appliance.
3. If the end of the drain hose looks like this (see
the picture), you can push it directly into the
stand pipe.
4. To a stand pipe with vent-hole - Insert
the drain hose directly into a drain pipe. Refer to
Washing Machine User Manual