Smps Board - Samsung ML-5200A Service Manual

Disassembly and Reassembly
3-5 Side Covers (Left, Right)
1. Before you remove these side covers, you
should remove:
-Front cover (see page 3-2)
-Top cover and Rear cover (see page 3-3)
2. Remove two screws on the back of the covers.
3. Unlatch the left and right side covers, and
remove them.

3-6 SMPS Board

1. Before you remove the board, you should
remove:
-All covers (see pages 3-2, 3-3,3-4)
2. Turn the printer upside down.
3. Pull the PCB controller Ass'y slightly
3-4
4. Remove foue screws and,unplug all the
connectors from the Shield, then take out the
SMPS board.
Shield
Samsung Electronics