Power Amp (Sold Separately); When Installing The Microphone On The Sun Visor; When Installing The Microphone On The Steering Column - Pioneer DEH-7300BT Installation Manual

Section
02
Connections

Power amp (sold separately)

Perform these connections when using the
optional amplifier.
3
1
2
 
5 5
 
3
2
1
 
7 7
 
3
2
1
 
9 9
 
1 System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connect with RCA cable (sold separately)
4 To Rear output
5 Rear speaker
6 To Front output
7 Front speaker
8 To subwoofer output
9 Subwoofer
6
En
4
6
8
Installing the microphone
CAUTION
It is extremely dangerous to allow the micro-
phone lead to become wound around the steer-
ing column or gearstick. Be sure to install the
unit in such a way that it will not obstruct driving.
Note
Install the microphone in a position and orienta-
tion that will enable it to pick up the voice of the
person operating the system.
When installing the
microphone on the sun visor
1 Install the microphone on the micro-
phone clip.
1
2
1 Microphone
2 Microphone clip
2 Install the microphone clip on the sun
visor.
With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the voice
recognition rate.)
1
2
1 Microphone clip
2 Clamp
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
When installing the
microphone on the
steering column
1 Install the microphone on the micro-
phone clip.
1
2
3
4
1 Microphone
2 Microphone base
3 Microphone clip
4 Fit the microphone lead into the groove.
# Microphone can be installed without using
microphone clip. In this case, detach the micro-
phone base from the microphone clip. To detach
the microphone base from the microphone clip,
slide the microphone base.
En
Section
03
7