Chapter 1: Connections & Setup; Things To Consider Before You Connect; Protect Against Power Surges; Protect Components From Overheating - RCA 1616362B User Manual

Things to Consider Before You Connect

Protect Against Power Surges

• Connect all components before you plug any of their power cords into the wall
outlet.
• Turn off the TV and/or component before you connect or disconnect any
cables.
• Make sure all antennas and cables are properly grounded. Refer to the
Important Safety Instructions packed separately.

Protect Components from Overheating

• Don't block ventilation holes on any of the components. Arrange the
components so that air can circulate freely.
• Don't stack components.
• If you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the
heated air from it won't flow around other components.

Position Cables Properly to Avoid Audio Interference

• Insert each cable firmly into the designated jack.
• If you place components above the TV, route all cables down the side of the
back of the TV instead of straight down the middle of the TV.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also,
keep the twin lead cables away from audio/video cables.

Important Stand and Base Safety Information

Choose the location for your TV carefully. Place the TV on a stand or base that is of
adequate size and strength to prevent the TV from being accidentally tipped over,
pushed off, or pulled off. This could cause personal injury and/or damage the TV.
Refer to the Important Safety Instructions packed separately.

Use Indirect Light

Don't place the TV where sunlight or room lighting will be directed toward the
screen. Use soft or indirect lighting.

Cables Needed to Connect Components to Your TV

The pictures below show the cables needed for the connections represented in this
book.
Coaxial cable
Chapter 1
Graphics contained within this publication are for representation only.
Chapter 1: Connections & Setup
S-Video cable
Audio/Video cables
Component Video (Y, Pb, Pr) cables
3