Lectrical ) P Ower; Connecting The Ac (Electrical) Power; Connecting The Rf Module; Registering The Handset - RCA 25413 User Manual

Connections and Setup

Connecting the AC (Electrical) Power

Plug the power adaptor cord into the power jack on the
back of the base and the other end into an electrical
outlet. The charge/in use indicator turns on to indicate the
battery is charging when the handset is on the cradle.
Allow the phone to charge for 12 hours prior to first
use. If you do not properly charge the phone, battery
performance is compromised.
CAUTION: Use only the 5-2652 power adaptor that came
with this unit. Using other power adaptors may damage
the unit.

Connecting the RF Module

Insert the RF module into the back of the base unit until
it snaps into place. The display wi
module is connected properly.

Registering the Handset

NOTE: Handset must be registered to the base to be
operational.
Once a handset is registered it can use the base phone's
connection. A cordless handset will not operate until it is
registered to a base. During the registration process, keep
the handset near the base.
NOTE : At initial power up, display will show "PLEASE
REGISTER". To continue registration from this point,
proceed to step #4.
1. On the handset, press the MENU button once, and then
press the 4 button until REGISTRATION shows on the
display.
2. Press the SELECT/SAVE button or the STORE button to
select Registration mode.
3. Press the 3 or 4 button on the handset to select YES.
4. Press SELECT/SAVE to confirm. The display shows
REGISTER....
5. On the base, press and hold the PAGE button for 3
seconds. If the registration is successful, the handset
will emit a long beep.
6. If the registration fails, FAIL! TRY AGAIN will show on
the handset display. Please repeat the above steps.
10
l show when the RF